When you want to smoke, but odour is of concern, you need to take precautions.  One classic solution to the marijuana smell problem is a simple device referred to as a sploof.  This guide describes the process of constructing one of these homemade odour-eliminators.

The pictures used in this guide were submitted anonomously though email.  The directions were unreadable, but to whoever sent the pictures, I thank you.

You Will Need: (See figure 1)

• Empty Paper-towel/Toilet-paper Roll
• Several Dryer Sheets (Fabric Softener)
• Duct Tape or Rubber Bands

Directions

Begin by taking 3-4 dryer sheets and placing them over one end of the paper towel roll. (See figure 2 and figure 3)

Next, seal the dryer sheets onto the paper towel roll with duct tape. (See figure 4)

Crinkle up the remaining dryer sheets.  (See figure 5)

Stuff the crinkled up dryer sheets into the open end of the sploof.  (See figure 6)

...and your sploof is ready for clandestine smoking!  (See figure 7)

Use and Tips

To use the sploof effectively, simply take your hit and exhale through the sploof.  The smoke will be filtered through the dryer sheets and will be expelled nearly odour-free!

Be careful, because only smoke that is filtered by the sploof can be deoderized.  Use a pipe and place a quarter over the bowl as soon as you are done taking your hit to minimize the impact of escaped smoke.

Test out the sploof in a safe location before using it in a high-pressure situation to make sure it deoderizes properly.

Figures Used In This Guide